The Heavy Duty series is designed & built for the boats that need extra strength to support them in rougher water at higher speeds.
Blades are constructed of Electro-Polished 12 gauge (2.7 mm) laser cut 304 stainless steel with 1” (2.5 cm) turned up edges and a 5 degree taper on the inside, heavy duty hinge with 1/4” (6.4 mm) diameter hinge pin.
Full transom back plate with welded on stainless steel upper & adjustable lower actuator mounting brackets, 5/16 (.8 cm) stainless steel mounting bolts & mechanical strain-relief cable seals. 3.75” (9.5 cm) sacrificial anodes installed.
Size :  ” 16″ L X 12″ W.
Voltage : 12V.
Boat Length :  20′ – 38′.
Min. Transom Height : 10.5″ (26.7 cm).
Each kit contains :
(2) 12-gauge stainless steel Electro-Polished blades.
(2) 15055-001 XD Extreme Duty actuators with 6’ (1.8 m) leads & Deutsch connectors.
(2) 30133-103 actuator extension wiring harnesses – 20’ (6.1 m) length.
Lenco owner’s/installation manual.

16″ X 12″ Heavy Duty Trim Tab kit without Switch